B100 4P 60KA~100KA ~420V AC 3P+N SPD House Surge Protector Protective Low voltage Arrester Device Lightning protection

B100 4P 60KA~100KA ~420V AC 3P+N SPD House Surge Protector Protective Low voltage Arrester Device Lightning protection
  • Продавецflimmer.com
  • Список ценUS $21.93piece
  • Продажная ценаUS $21.93piece
  • ДоставкаБесплатная доставка
  • Рейтинги3,8 (167)

Oписание продукта

imageProducts Description     
TTS RJ45 1000M six twisted pair Ethernet data communications surge protector

Applied to the lightning region LPZ1- LPZ2 partition interface, providing full protection line 8. TTS-RJ45-E1000 / 8S can protect a 1000M Ethernet standard twisted-pair cable, RJ45-8E, 16E, 24E, respectively protection 8, 16 and 24 twisted-pair Ethernet standard six-way 1000M

Products Type
TTS-RJ45-E1000/8S TTS-RJ45-16E-1000M TTS-RJ45-24E-1000M TTS-RJ45-8E-1000M

Products Introduction

TTS RJ45 E1000/8S six Ethernet data line surge protector according to TIA / EIA 568B-2.1 and ISO / IEC 11801 standard design, E-Class is six cable or Ethernet cable structured cabling systems and other similar applications ideal the fully shielded surge protector. Universal RJ45 connection port, the product can be easily connected in front of the protected equipment; quality, high discharge capacity of surge protection devices and low capacitance, ultra-fast recovery diode matrix structure that provides high energy level protection for data lines coarse low energy and fine protection, which effectively absorbs and transfers the energy generated by lightning and surge impact and energy through the grounding cable into the earth, and ultimately protect sensitive electronic equipment from damage. Products with good frequency transmission characteristics, high-pass flow and fast response speed, can be widely used in office and industrial premises network cabling and similar data communication systems, such as the 1000M Ethernet, ATM, ISDN, VoIP network, PoE systems.

Product Features:

1 core device selected by an international brand, 8-wire full protection, superior performance, lightning fast response, can effectively prevent the various frequencies of lightning

2 multi-level protection, lightning currents can fight 5kA, and after testing authority, in accordance with international and domestic standards

3 insertion loss, when the 1000M is less than 0.3dB, guaranteed to reach 1000M rate

4 workmanship, easy to install, can be connected to a standard rail card, easy maintenance and management

 

TTS-RJ45-E1000/8S Schematics

gcal06

 

TTS-RJ45-16E-1000M

 

TTS-RJ45-24E-1000M

Size Chart

TTS-RJ45-E1000/8S

RJ45-16/24E-1000M Size

Technical Data

Type

Input

TTS-RJ45-E1000 /8S

Nominal Voltage

Un

48V

Max.Countinous operation voltage

Uc

48V- / 34V

 

IL

200mA

C2 line - the line between the nominal discharge current (8/20μs) L-L

In

100A

C2 Total nominal discharge current 8/20μs

In

10kA

C2 line - between the ground nominal discharge current 8/20μs L-PG

In

2.5kA

C2 IN voltage protect level L-L

Up

≤130V

C2 IN voltage protect level L-PG

Up

≤600V

Insert Loss 250MHz

 

0.3dB

Max.transfer speed

Vs

1000M/s

Responce Time

tA

<1ns

protecting core wire

 

1/2, 3/6, 4/5, 7/8

Protect level

 

IP20

Input / output interface

 

RJ45

Installation Rail

 

15mm

Operation Temperature

T

- 20+ 50

 

Applications

TTS-RJ45-E1000/8S primarily for a single Gigabit Ethernet port for surge protection, suitable for protecting a single computer or server, RJ45-8E/16E/24E protection respectively 8, 16 and 24 Gigabit Ethernet network standard twisted pair cabling standards applicable to lightning six systems SWITCH, HUB, ROUTER and computer network equipment, or other surge protection

 

Product Installation

LPZOB-1 interface or higher interface can be installed lightning protection district, while protecting all the way or gigabit network line. When installing wiring, signal data is protected line should be surge current end of the cable and ground wire unprotected contaminated; grounding wire should be grounded via the shortest possible path length not more than 1.5 meters; data cable bending radius not less than 35mm.

Note the direction of the cable out of the installation, there are "IN" and "OUT" sign. "IN" is always a non-protected side, and indicate the direction of voltage that may arise over the protection side "OUT" points to the protected area or equipment grounding conductor by equipotential connections should be installed as close to the equipment to be protected. TTS-RJ45-E1000/8S can be easily mounted on 15/35mm standard rail, RJ45-8E, 16E, 24E product is only one vertical unit height (1U), take up less space, and through 90 °, 180 ° and 270 ° rotating mounting bracket supports a variety of horizontal and vertical installation, particularly suitable for installation in a 19 "rack. attention out of the surge protector cable when installing wiring should be separated to avoid the emergence of a secondary coupling surge.

 

Product Maintenance

When routine maintenance and overhaul of the product, to measure the resistance between each pair twisted when megohms resistance is an order of magnitude, which means that the product is normal; When the resistance of only a few in Europe, which means that the product has been damaged, must be replaced immediately .

RJ45-E1000/8S wiring diagram

TTS-RJ45-8E/16E/24E network surge protector 19-inch rack installation diagram

 

DDN Telecom Data Line Protection: RJ45-DDN/4S

1000M Ethernet twisted-pair protection: RJ45-E1000/8S

16/24 port 10/100M Ethernet switch protection: RJ45-16E, RJ45-24E

single-port 10/100M Ethernet network protection: RJ45-E100/4S

 

Data center / central office network communication protection schematic

Tip: twisted-pair Ethernet surge protector Typically, network switches and servers arranged in the same room, and the close proximity, it is usually installed in the HUB Network mine entrance end, so you can protect the switch and server. If the port install surge protectors only NIC server, the server can only protect switch is still dangerous lightning surge invasion. For the possibility of being struck by lightning surges overhead lines maximum, this case should be separately install surge protectors in the home network at both ends.

Order information

Item no.

Type

Specification

30051

TTS-RJ45-E1000/8S

1000M Single-port Ethernet network protection

30052

TTS-RJ45-16E-1000M

1000M 16 Ethernet Network Protection, 19 "standard rack mount

30053

TTS-RJ45-24E-1000M

1000M 24 Ethernet Network Protection, 19 "standard rack mount

30054

TTS-RJ45-8E-1000M

1000M8 Ethernet network protection, 19 "standard rack mount

1

2